Changing Rear Brake Pads

October 08, 2021

Replace the retaining clips. You should also install the wheels again and lower the car.

How To Replace Rear Brake Pads And Rotors Youtube

Step 3 - Remove the Brake Pads.

Changing rear brake pads. Put the two 12mm bolts back into the caliper and tighten them down. Ad MyZone Offers a Full Range of Training Solutions to Suit Any Budget. Get Results from 6 Engines at Once.

Remove the slider bolt. Your vehicles owners manual likely recommends inspecting the pads at every oil change because brake-pad life can vary greatly depending on your driving. Place axle stands under the vehicle in addition to the jack for extra safety.

Pivot the caliper up. One more thing you need to do when you put the new brake pads in or you inspect yours and theyre if theyre fine you put the back the old one. Remove the wheels where youre replacing the brake pads front or rear.

Thats it for this quick tip Hope you enjoy it but remember if youre not comfortable doing this on your own bring the the bike to the dealership for service. Slide out the old brake pads. You must push the piston back into the caliper to be able to rotatefit the caliper over the rotor and the 2 new thicker rear brake pads.

Step 2 - Remove the Guide Pin Bolt. Be sure to check your brake fluid level after you move everything around and change it if necessary. You should check your brakes regularly for signs of wear and leaks in the system.

Line the U-shaped spring up with the grooves in the brake pads so it is in between them and the pads are facing each other. Ensure it is securely supported on a level surface. Use one spanner to hold the guide pin and unscrew and remove the guide pin bolt.

Pads need checking and changing more regularly than the discs but remember if youre pad wear too badly you will damage your discs. Ad MyZone Offers a Full Range of Training Solutions to Suit Any Budget. Get Results from 6 Engines at Once.

Once you cleaned everything and installed the new brake pads reinstall the brake caliper. Steps for changing your brake pads. Take the caliper and slide it over the brake pads.

Changing Brake Discs and Pads is part of routine maintenance that has to been done as the parts wear out. This can be a hassle due to the tight fight but just wiggle it on there a little bit should slide right on. Make sure that you tighten everything correctly after the manufacturers specifications.

Squeeze the pads together to sandwich the spring inside. You have to press on the brake a couple of times to put the piston back into place. Ad Search Brakes Changing.

Ad Search Brakes Changing. Put the new pads in the accompanying spring and squeeze them together. You must do the procedure first so that when you manually push the piston back into the caliper you do not damage the e-brake.

So thats it alright guys.

Change The Rear Brake Pads On A Honda S2000